﹛﹛computer aided analysis,計算机輔助分析
computer aided control engineering,計算机輔助控制工程
computer aided debugging,計算机輔助故障診斷
computer aided design,計算机輔助設計
computer aided design of control system,控制系統計算机輔助設計
computer aided engineering,計算机輔助工程
computer aided manufacturing,計算机輔助制造
computer adied planning,計算机輔助規划
computer aided production planning,計算机輔助生產計划
computer aided quality control,計算机輔助質量控制
computer aided quality management,計算机輔助質量管理
computer aided researching and developing,計算机輔助研究開發
computer aided testing,計算机輔助測試
computer and computing hardware,計算机和計算硬件
computer assisted management,計算机輔助管理
computer auto-manual station,計算机自動/手動操作器
Computer Automated Measurement and Control,(CAMAC),計算机自動測量和控制
computer control,計算机控制
computer control system,計算机控制系統
computer integrated manufacturing system,計算机集成[綜合]制造系統
computer network,計算机网絡
computer simulation,計算机仿真
computer system,計算机系統
concave grating,面光柵
concentrating flux plate,導磁板
concentrating flux sleeve,導磁套
concentration,濃度
concentration cell,濃度電池
concentration of tracer,示蹤物濃度
concentration sensitive detector,濃度敏感型檢測器
concetric orifice plate,同心孔板
condensation,凝露
condenser lens,聚光鏡
condenser microphone,電容傳聲器
condition,狀態；條件
conditional instability,條件不穩定性
conditional stability of a linear system,線性系統的條件穩定性
conditionally stable system,條件穩定系統
conditioning,調節；環境負荷
conductance,電導
conducting electrical instrument,傳導類電法儀器
conductive gas transducer[sensor],電導式气体傳感器
conductive level transducer[sensor],電導式物位傳感器
conductivity,電導率
conductivity cell,電導池
conductivity instrument,電導率儀器
conductivity sensor,電導率傳感器
conductometer,電導儀
conductometric analysis,電導分析（法）
conductometric analyzer,電導式分析器
conductometric titration,電導滴定
cone plug,圓錐形閥芯
cone-and-float flowmeter,盤塞式流量計
cone-and-float flowmeter,浮子流量計
cone-plate viscometer,錐﹛板粘度計
confidence level,置信水平
confidence limits,置信界限
configuration,配置；組態
configuration of hardware,硬件的配置
conformance test,合格試驗
conformance testing,一致性測試
conformity,一致性
conformity certification,合格認証
conformity error,一致性誤差
conical bearing,錐形支承
conical entrance orifice plate,錐形入口孔板
connecting link,連杆
connecting resistance(for potential),（電位）連接電阻
connecting wire error,連接線誤差
connector,接插件
consistency,一致性
consistency check,相容性檢驗
consistency transmitter,濃度變送器
console，操縱台
console printer,控制台打印机
constant bandwidth filter,恒定帶寬濾波器
constant current power supply,恒流電源
constant-head flowmeter,恒定壓頭流量計
constant-level head tank,恒液位壓頭容器
constant of a measuring instrument,測量儀表[器具]的常數
constant-rate injection method,恒定速率注入法
constant state,恒定狀態
constant-temperature method of reference junction,參比端恒溫法
constant voltage/constant,恒壓恒流交疊
constant voltage power supply,恒壓電源
constriction(of liquid-in-glass thermometer),（玻璃溫度計的）縮喉
constructional hardware,結构硬件
consumer package,銷售包裝
conteact anemometer,接触式風速表
contact controlled electric actuator,有触點電動執行机构
contact electric position transmitter,有触點位置發送器
contact electromotive force,接触電熱勢
contact head,触頭
contact mercury barometer,電接點水銀气壓表
contact pads,接触墊
contact resistance,接触電阻
contact scanning method,接触法
correlation coefficient,相關系數
correlation length measuring instrument,相關式測長儀
correlative method INPUT system,相關對比法感應脈衝瞬變系統
